Tweco Eliminator Spool Gun - Manual (Page 16)

4-12
safety and operating instructions
89200011
SECTION 4:
STANDARD SETUP
NOTE
Be certain that the end user (welder, operator, or helper) reads and understands
these instructions. Be certain that the welder also reads Section 2, "Safety
Precautions."
WARNING
Electric shock can cause injury or death.
The Eliminator Spool Gun requires 24VDC power for the motor inside the handle to feed the
wire from the spool. For power supplies having the capability to supply the 24VDC, no added
modules will be required to operate this MIG gun. A 10-pin amphenol plug is attached to the
cord coming out of the rear of the MIG gun that can be either attached directly to the mating
connection on the machine or through jump cords, refer to available options noted below:
Control Wire Jumper Cords
Manufacturer Machine Part Number Stock Number
Miller Millermatic 210 WSPMIU4PJC2 2031-2246
Miller Millermatic 212 WSPMILLOPJC 2031-2246
Lincoln Power MIG 255C WSPLIN7PJC 2031-2247
Hobart Ironman 210, 250 WSPMILL4PJC 2031-2245
Esab Migmaster 203 WSPESAB7PJC 2031-2248
Esab Migmaster 253 WSPESAB7PJC 2031-2248
Esab Migmaster 250 WSPESAB7PJC 2031-2248
Generic See pin configuration WSPESAB7PJC 2031-2249
For those that cannot supply the 24VDC from a power source, Part No. ESG-1 Solid State
Control Box (Stock No. 1028-1295) will be required to interface with the power source. Refer
to Section 5 on the operation of the ESG-1 control box.
NOTE
When connecting the Spool gun to a Thermal Arc Arcmaster & Power Master
series power sources, use the Thermal Arc SGI-100 Spool Gun interface box.
Follow the set-up procedures outlined in the SGI-100 Instruction Manual, Form
No. 0-5061.
Standard Setup