Tweco Eliminator Spool Gun - Manual (Page 29)

safety and operating instructions
14-25 89200011
SECTION 14:
LINER GUIDE ASSEMBLY REPLACEMENT
1. Remove conductor tube and proceed with removing the conduit liner guide assembly
with a 3/8" wrench and flat screwdriver.
2. Replace liner into guide.
3. Screw liner guide into gun and attach
nut. Do not overtighten nut.
4. Install new assembly into block using
pliers or a 3/8" open end wrench and
screwdriver.
5. If using the white Teflon liner in the front
steel liner guide, the liner should be 1 3/4"
(44,5mm) long and protrude out the rear
of the guide (threaded end) 1/8"- 3/16"
(3,2mm - 4,8mm).
6. The plated steel or copper liner guide
that anchors the conduit between the
gun drive roll and conductor tube should
protrude no more than 1/8" (3,2mm) from
the gun body after assembly.
NOTE
Make sure the white liner is
not forced back against the
gun drive roll.
Liner Guide Assembly Replacement