Viking Pump TSM641.3: Eaton Mod 80 Y-Strainer - Manual

Installation, Operation &
Service Manual
Models 80 & 85
Y-Strainers
IOM 80/85 01/06 1
Table of Contents
Page No.
Introduction……………………………….. 1
Receiving, Handling & Inspection ……… 2
Installation ………………………………… 2
Start-Up . …………………………………. 3
Screen Cleaning …………………………. 3
Shut-Down Periods ……………………… 3
Recommended Spare Parts ……………. 3
Introduction
The Eaton Models 80 & 85 Y-Strainers are de-
vices installed in a pipeline to remove dirt and
other unwanted debris from fluids. They are de-
signed for the full ANSI pressure rating @ 100°F
that is shown on the strainer. Straining is accom-
plished by directing the fluid through sized open-
ings in a screen. Y-Strainers are installed where
fluid flow can be interrupted while the screen is
removed for cleaning. Y-Strainers are designed
to withstand the pressures of the piping system.
For additional information regarding Y-Strainers
visit out website at:
www.filtration.eaton.com
Read all instructions before installation or
operation of equipment. Failure to comply
with these instructions could result in
bodily injury or property damage.
Eaton Filtration, LLC
900 Fairmount Avenue, Elizabeth, NJ 07207
Phone: 908-787-1000 Fax: 908-351-7893
E-Mail: [email protected]
Web: www.filtration.eaton..com