LaMotte DO 6 Dissolved Oxygen Meter - Manual (Page 26)

6 HOLD Function
This feature lets you freeze the display for a delayed observation. HOLD can be
used in any measurement mode.
1. To hold a measurement, press the HOLD/ENTER key while in
measurement mode. The %, mg/L, ppm or T annunciator in the display
will start blinking to indicate that the measurement is being held.
2. To release the held value, press the HOLD/ENTER again. The
annunciator will stop blinking to indicate that the held value has been
released.
3. Continue to take measurements.
Note: This meter has a selectable auto off feature which when activated will
shut the meter off automatically after 20 minutes of non use.
If the meter is shut off either automatically or manually, the HOLD value will
be lost.
7 ADVANCED SETUP FUNCTIONS
7.1 Advanced Setup Overview
The advanced setup mode lets you customize your meter’s preferences and
defaults. There are two Set Up menus: - one which is derived from the %
Saturation or Temperature mode and the other is derived from the mg/L (ppm)
Concentration mode.
7.1.1 To enter the % Saturation or Temperature Set Up menu:
1. Make sure that the meter is switched-off while in the % Saturation or
Temperature measurement mode.
25
70.5
A
Annunciator Blinks when
meter is in “HOLD” mode
Figure 68: Unit in HOLD mode
%