Wheatheart Swing Away Flex Auger - Manual (Page 37)

W HEATHEART - SA F LEX A UGER 3. A SSEMBLY
71’ - 111’ 3.8. T RUSS 111’
30651 R5 37
3.8.1. C
ABLE
T
RUSSING
1. Attach an eyebolt to one end of each of two
truss side cables with two 3/8” cable clamps using
about 10” (25.4 cm) to 12” (30.5 cm) of cable.
Tighten securely (Figure 3.20).
2. Insert eyebolts into tabs located on flex frame.
Secure with 1/2” locknut (Figure 3.19).
3. Loosely attach the truss cables to each cable
support arm with a 5/16” cable clamp as shown in
Figure 3.18.
4. Attach remaining eyebolts to adjust bracket and
thread on 1/2” locknuts about 1/2” (Figure 3.20).
5. Thread loose ends of the cable through each
eyebolt, pull tight, then secure with two 3/8” cable
clamps (Figure 3.20). Tighten securely.
6. Adjust tension of side truss cable by tightening
the eyebolts at the adjust brackets. These cables
must be very tight. Also adjust for side alignment.
7. Now tighten all of the cable clamps at cable
supports and arms.
Figure 3.20
Figure 3.19 111‘Auger
10-12”

( 25.4 - 30.5 cm)
ADJUST
BRACKET EYEBOLT
NUT 3/8” CABLE CLAMPS