Wheatheart Swing Away Flex Auger - Manual (Page 45)

W HEATHEART - SA F LEX A UGER 3. A SSEMBLY
71’ - 111’ 3.9. S CISSOR L IFT F RAME (71’–91’)
30651 R5 45
3.9.2. A
TTACHING TO
T
UBE
1. Remove the stand from the intake end of the auger and raise the discharge
end with a block and tackle or a front end loader and a strong sling or chain
at point “A” (Figure 3.31). Height should be sufficient so the frame can be
positioned under the tube.
2. Position the frame under the tube assembly.
3. Lower the tube to align the upper scissor with the bracket closest to the
center cable bridge on the tube (29).
• Secure in place using 1” x 2-1/2” bolts (30) and 1” locknuts (31).
• Use two 1” SAE washers (32) as spacers between the tabs and the
bracket (1 for each side). See Figure 3.24.
Table 3.2
Model U V W X Y Z
71’
167”
(4.24 m)
89”
(2.26 m)
149” w/ Trussing
(3.78 m)
60-1/8”
(1.52 m)
229”
(5.82 m)
102”
(2.59 m)
81’
178”
(4.52 m)
71”
(1.80 m)
167-3/4” w/ Trussing
(4.26 m)
59-13/16”
(1.52 m)
288”
(7.32 m)
102”
(2.59 m)
91’
220”
(5.59 m)
112”
(2.84 m)
189-1/2” w/ Trussing
(4.81 m)
58-7/16”
(1.48 m) 353”
(8.97 m)
102”
(2.59 m)
WARNING
Components are heavy and create a crushing
and pinching hazard if improperly handled. Be
sure to use proper hoisting equipment and
procedures, and ensure lifting apparatus is
secure before working around or under the
raised components. Failure to do so may
cause serious personal injury.