Wheatheart Swing Away Flex Auger - Manual (Page 81)

W HEATHEART - SA F LEX A UGER 4. T RANSPORT & P LACEMENT
71’ - 111’ 4.2. P LACEMENT P ROCEDURE
30651 R5 81
4.2. PLACEMENT PROCEDURE
1. Ensure PTO driveline is disconnected from tractor and secured in transport
saddle.
2. Ensure that towing hitch is in place and secure.
Important: Use a type of hitch pin (see Figure 4.2) that will not allow auger to separate from
towing vehicle.
3. Ensure that the auger is on reasonably level ground when raising, lowering,
or when positioning.
4. Before raising or positioning auger, make sure that entire area in line of
travel, both on the ground and overhead, is clear of any obstructions or
electrical wires.
Important: Because of the many different kinds of tractor hydraulic systems, the quick-
connect coupler must be supplied by the owner. Please consult your tractor
manual or dealer for the proper coupler.
5. Before connecting the auger and tractor hoses, wipe off the quick-connect
couplers.
6. Connect hydraulic hoses tightly. Check for leaks, binding, flattening, kinks, or
wear.
7. If the auger must be raised for positioning:
a. Check that valve on hose to lift cylinder is open.
NOTICE
When positioning, PTO driveline must be disconnected
from the tractor and placed in the transport saddle to
prevent damage to auger and PTO driveline.
NOTICE
To prevent equipment damage, hydraulically lift the
outriggers before raising or lowering the auger.
CAUTION
If auger wheels are partially or fully buried in
snow or grain, failure to clear the area around
the wheels before moving may cause damage
to the auger or result in serious injury.
NOTICE
Dirt in the hydraulic system can damage the cylinder o-
rings, causing leakage and the possible failure of the
system and personal injury.