Wheatheart R Series Augers - Manual (Page 17)

W HEATHEART - R S ERIES A UGERS 3. T RANSPORT
R8-36, R8-41, R8-46, R8-51, R10-36, R10-41, & R10-51
30758 R1 17
8. Install the safety chain between the auger and the frame of the towing unit.
Important: The chain must have a load rating at least as high as the auger weight.
CAUTION
After lowering auger, always turn winch
handle clockwise at least 2 clicks to tighten
brake lock.
Maintain control of winch handle at all times.
Maintain light cable tension when in towing
position.
Do not put lubrication on brake disc.
Check cable before each use and replace if
frayed or damaged.
Make certain that cable clamps are securely
tightened.
S AFETY C HAIN
• The safety chain should be threaded through the handle on the lower
tube, and wrapped around the auger tube before attaching to the towing
vehicle.
• The loop should form a cradle that will prevent the auger from digging
into the road surface or upsetting, should a breakaway occur.
• Ensure there is no more slack in the chain than required for turning.
• When not in use, store the safety chain in a clean, dry place. Replace
the safety chain if one or more links or end fittings are broken,
stretched, or otherwise damaged, or deformed.