Wheatheart R Series Augers - Manual (Page 19)

W HEATHEART - R S ERIES A UGERS 4. P LACEMENT
R8-36, R8-41, R8-46, R8-51, R10-36, R10-41, & R10-51
30758 R1 19
4. Placement
When placing the auger, follow these instructions and see Figure 4.1.
1. Check for power lines or any obstructions that may damage the auger.
2. Move the machine under the truck or storage facility.
3. Place the auger on a firm, level surface.
4. Chock the wheels before augering any products.
5. Always use a vehicle or mover to move the auger. Never move it by hand.
6. Do not place anything under the wheels to add height to the auger.
7. To prevent upending or the wind upsetting the auger: when operating the
auger in raised position, rest the discharge end on the bin roof or tie it down
to the bin. When operating the auger in a free-standing position, anchor the
intake end.
.
Figure 4.1
DANGER
Electrocution hazard:
• This auger is not insulated.
• Keep auger away from overhead power
lines and devices.
• Electrocution can occur without direct
contact.
• Fully lower auger before moving.
Failure to keep away will result in serious
injury or death.
Warning:
Before continuing, ensure you have read and understand the relevant information
in the safety section. Safety information is provided to help prevent serious injury, death, or
property damage.