Section 6 troubleshooting, Troubleshooting – Great Plains PT8030 V1012 Operator Manual User Manual
Page 44
42
Section 6 Troubleshooting
10/10/12
PT6030 and PT8030 Pull-Type Planter 401-032M
Great Plains Mfg., Inc.
Section 6
Troubleshooting
Problem
Possible Cause
Solution
One row not planting seed.
Drive clutch release not engaged.
Engaged clutch release mechanism.
Foreign material in hopper.
Clean hopper and finger carrier mechanism.
Seed hopper empty.
Fill seed hopper.
Row unit drive chain off of sprocket or broken.
Repair or replace drive chain.
Drive not functioning.
Inspect all drives.
Drive release does not engage properly.
Drive release shaft isn’t aligned properly with
meter drive shaft.
Align drive mechanism. See “Meter Drive
Adjustment”.
Unit is skipping.
Foreign material or obstruction in meter.
Clean out and inspect.
Finger holder improperly adjusted.
Adjust to proper setting. (22 to 25 inch pounds
torque)
Loose finger holder.
Adjust tension of finger pickup.
Broken fingers.
Replace fingers and/or springs as required.
Planting too slowly.
Increase planting speed to within recom-
mended range. See charts for correct speed.
Planting too many doubles.
Planting too fast.
Stay within recommended range.
Lose finger holder.
Adjust to specifications (22 to 24 inch pounds
torque)
Worn brush in carrier plate.
Inspect and replace if necessary.
Over planting.
Worn carrier plate.
Inspect and replace if necessary.
Under planting.
Belt installed backwards.
Remove and install correctly.
Weak springs.
Replace.
Spring not properly installed.
Remove finger holder and correct.
Seed belt catching or dragging.
Replace belt.
Brush dislodging seed.
Replace brush.
Irregular or incorrect seed spacing.
Driving too fast.
Check chart for correct speed.
Wrong tire pressure.
Inflate tires to correct air pressure.
Drive wheels slipping.
Reduce down pressure on row unit down force
springs.
Wrong sprockets.
Check planting rate charts for correct sprocket
combinations.
Seed spacing not as indicated in charts.
Wrong tire pressure.
Inflate tires to correct air pressure.
Inconsistent seed size.
Do field check and adjust sprockets accord-
ingly.
Wrong sprockets.
Check chart for correct sprocket combination.
Charts are approximate.
Slight variations due to wear may produce
seed spacing variations.
Scattering of seeds.
Planting too fast.
Reduce planting speed.
Seed tube improperly installed.
Check seed tube installation.
Seed tube worn or damaged.
Replace seed tube.
Seed tubes and/or openers plugging.
Allowing planter to roll backward when lowering.
Lower planter only when tractor is moving forward.
Turning tractor steering wheel when planter is down
and stationary. (Four Wheel Drive tractors only.)
Avoid turning tractor when planter is down and sta-
tionary.