Appendix b - pre-delivery, Attach meter hoses at rows, Main seed hose – Great Plains 606NT Operator Manual User Manual

Page 71: Native grass hose, Small seeds hose, Install smv reflector

Advertising
background image

2014-02-10

Table of Contents

Index

151-061M

Great Plains Manufacturing, Inc.

Table of Contents

Index

67

Appendix B - Pre-Delivery

Attach Meter Hoses at Rows

All meter hoses are shipped disconnected at the row
units. Clamps are shipped inside a seed box. The opener
frame has openings for up to three material hoses:

• The forward hole

is always used for the seed

delivery tube for the main seed box.

• The center hole

is used for Native Grass, if installed.

• The rear hole

is used for Small Seeds, if installed.

Start with the left row unit (row 1). For each row:

Refer to Figure 59
Main Seed Hose
Select one:

800-008C CLAMP HOSE 1 1/2 NO. 24

Open the clamp

. Place it onto the outlet end of the

hose

, up against the ribs. Slide the outlet end of the

hose fully onto the seed tube inlet

at the forward row

unit opening

. Move the clamp to just below the raised

lip of the seed tube inlet.

Native Grass Hose
Select one:

800-346C CLAMP HOSE 2 5/8 #42

Open the clamp

. Place it onto the outlet end of the

hose

, up against the ribs. Slide the outlet end of the

hose fully onto the native grass tube inlet

at the center

row unit opening

. Move the clamp to halfway onto the

hose neck.

Small Seeds Hose
Select one:

800-321C HOSE CLAMP NO.12 3/4 ID

Open the clamp

. Place it onto the outlet end of the

hose

, up against the ribs. Slide the outlet end of the

hose fully onto the small seeds tube inlet

at the rear

row unit opening

. Move the clamp to halfway onto the

hose neck.

Install SMV Reflector

Refer to Figure 60
The SMV reflector

is shipped pre-assembled to the

mount

, but mounted inverted on the walkboard. The

SMV must be repositioned to upright to prevent contact
with row units during operation.

Remove and save two sets:

802-007C HHCS 5/16-18X3/4 GR5

804-009C WASHER LOCK SPRING 5/16 PLT

803-008C NUT HEX 5/16-18 PLT

Orient the reflector assembly

upright, and red/orange

reflective side to rear. Secure mount

to walkboard

with bolts

, lock washers

and nuts

.

Figure 59

Seed and Native Grass Hoses

32683

f

c

r

26

13

30

32

12

14

29

27

13

Note: These items are normally completed by the dealer

prior to delivery.

f

c

r

13

13

26

30

f

15

15

27

32

c

14

14

29

12

r

Figure 60

SMV Reflector

32648

20

33

23

17

34

33

34

17

23

20

34

34

17

23

20

Advertising
This manual is related to the following products: