Great Plains 3S-4000HD Assembly Instructions - Manual (Page 13)

Great Plains Manufacturing, Inc. Table of Contents Index Installation Instructions 9
2012-12-11 Table of Contents Index 133-322M
Mount Seed Boxes
Starting with the left section:
Refer to Figure 10
28. Select one of the following, new:
133-153K 2600 SML SDS RH BOX ASY 6 IN
133-155K 2600 SML SDS RH BOX ASY 7.5 IN
133-157K 2600 SML SDS RH BOX ASY 10 IN
29. Select four sets of new:
802-388C HFS 3/8-16X1 GR5
803-014C NUT HEX 3/8-16 PLT
804-013C WASHER LOCK SPRING 3/8 PLT
30. Mount the box at the forward set of open holes in
the mounts and drives just installed.
31. Repeat step 28 through step 30 for the center and
right sections
Install Guards and Corner Fittings
The new guards mount under the old corner fittings. If
the removed and saved bolts and nuts are not of the
flanged type, also re-install the washers removed with
them. The location of the washers is shown in the
Figures, but without callout numbers.
Start with the left section:
Left Box End Fittings
Refer to Figure 11,
which depicts the left section box without a manual pak.
32. Select one saved:
119-190D HANDLE
and if it was present, one saved:
248-251D MANUAL PAK MOUNTING PLATE
33. Select two sets saved:
803-169C NUT HEX FLG. LOCK 1/2-13 PLT.
802-203C HFSS 1/2-13X1 1/2 GR5
or HHCS bolts, flat washers and plain nuts.
34. Select one new:
123-491D HANDLE MOUNT LH CHAIN GUARD
Position it on the left small seed box mount. Position
the manual pak mount
(if any), then the
handle , and secure with bolts , nuts and
washers (if any).
U
D
L
R
B
F
129
140
133
109
108
107
129
140
133
Figure 10:
Mount a Small Seeds Box
27434
107
108
109
129
133
140
U
D
L
R
B
F
102
17
16
11
17
Figure 11:
Mount L. Guard, Corner Fittings
27435
11
14
17
16
102
14
11 16 17