Great Plains CP1000 Assembly Instructions - Manual (Page 10)

8
Section 1 Assembly Instructions & Set-Up
CPH and CP1000 Coulter Command System 148-258M-B 9/21/05
Great Plains Mfg., Inc.
1 1/2" x 4" gauge wheel lift cylinder base and elbow
fitting (#21). Connect the other 36" long 1/4" hose
(#22) between the port "C2" of the lower valve block
and the 1 1/2" x 4" gauge wheel lift cylinder rod end
elbow fitting (#21).
6. Route the three 16" wiring harness leads with the
weather-proof connectors, under the valve mount
and connect each lead to its solenoid. The lead la-
beled "A" should be plugged into the solenoid
marked "A", The lead labeled "B" should be plugged
into the solenoid marked "B," and the lead labeled
"S1" should be plugged into the solenoid marked
"S1."
Figure 5
Hydraulic Control Valve Assembly
13482