Great Plains CP1000 Assembly Instructions - Manual (Page 5)

3
Section 1 Assembly Instructions & Set-Up
9/21/05 CPH and CP1000 Coulter Command System 148-258M-B
Great Plains Mfg., Inc.
Pre-Assembly Checklist
Check
All major components
Fasteners that were shipped with the Coulter Command
System.
NOTE: Some of the hardware from the factory has been
installed in the location where it will be used.
Have a minimum of 2 people at hand while assembling the
Coulter Command.
Have a fork lift or loader along with chains and safety
stands ready for the assembly task.
If you are unsure where a fastener is used, use the parts
section of this manual to identify it. Be sure the part gets
used in the correct location.
Coulter Command Assembly
Depth Sensing Wheel
Refer to Figure 1
Install the coulter depth sensing wheel assembly (#1) to
the front 4" x 4" coulter tool bar tube with the 5/8" X 6"
long U-bolt (#2), lock washers (#3), and nuts (#4). The
center of the coulter depth sensing wheel mount bracket
should be positioned 2 1/4" to the right of the center of
the hitch center beam. This dimension leaves about 2 3/
4" clearance between the inside edge of the depth sens-
ing tire and the edge of the 8" X 8" hitch center beam.
12613
Section 1
Assembly Instructions & Set-Up
Figure 1
Coulter Command Assembly