Great Plains 1500TM Assembly Manual - Manual (Page 20)

16 1200-1500TM Great Plains Manufacturing, Inc.
586-535Q-ENG 12/12/2013
Lights and SMV Assembly
Refer to Figure 14
54. Fasten LH and RH light brackets to center
frame with 1/2 x 3 1/32 x 6 u-bolts , 1/2 lock wash-
ers and 1/2 huts.
55. Attach smv mount to rear tube of center frame,
with 1/2 x 3 1/32 x 6 u-bolts , 1/2 lock washers and
1/2 huts. Attach smv sign to back side of smv
mount , secure with 1/4 x 3/4 pan head screws ,
1/4 lock washers and 1/4 nuts.
56. Route light harness 30’ lead from front of hitch
(tractor plug to front), along same route as hydraulic
hose (fasten in same clamps and hose wraps as
hoses). Plug one end of enhance light harness
to
small end of light harness 30’ lead . Plug bigger
end of wishbone light harness into other end of
enhance light module . Route other ends over
towards (marked left and right) the light mounting
brackets as shown.
57. Mount red lamp lights to center frame plates with
1/4 x 1 Gr. 5 hex bolts and 1/4 lock nuts.
58. Mount amber lamp lights to top of light brackets
and , with 1/4 x 1 1/4 Gr. 5 hex bolts and 1/4
lock nuts.
59. Tighten all bolts with lock nuts snug, but do not
torque. The rest of the bolts may be tightened to
specs, See “Torque Values Chart” on page 24. Be
sure and get all wiring harnesses fastened up
securely with hose wraps or clamps (if routed close
to hydraulic hoses) or use cable ties
.
1 2
3
4
3
5
4 6
7
8
7
9
8
10
12
11 1
2 12
13