Great Plains ADI334 Predelivery Manual - Manual (Page 11)

9
Section 2 Setup
4/7/04 Models ADI334 and ADI345 Air Drill Implement 160-243M
Great Plains Mfg., Inc.
Section 2
Setup
This section covers dealer requirements for implement
setup, including hitching the cart to the implement, bleed-
ing air from the hydraulics, leveling the frame, and install-
ing seed towers and hoses.
Hitching Cart to Implement
!
DANGER!
You may be severely injured or killed by being crushed between
the cart and the implement. Do not stand or place any part of
your body between the cart and implement while hooking up the
air drill.
Refer to Figure 2-1.
1. With cart links tied up, slowly back cart toward the
center of the implement.
2. When cart links (1) are aligned with the lower hitch
plates on the cart (2), drive link pins (3) in place. Se-
cure with roll pins.
Refer to Figure 2-2.
3. Make sure the cart sling (1) is connected to the cylin-
der lift arm (2), then align the top hole with the support
plates (3) on the back of the cart frame.
4. Install the cart sling pin (4) and secure it with the 1/4 x
2-inch cotter pins (5). Be sure cotter pins are spread.
Figure 2-1
Hitching Cart to Implement
Figure 2-2
Hose Routing and Sling Installation
5. Connect the primary seed hoses to the cart meter
box. Connect the hoses left-to-right in the same order
14461
16547