Great Plains ADI334 Predelivery Manual - Manual (Page 6)

4
Section 1 Assembly
Models ADI334 and ADI345 Air Drill Implement 160-243M 4/7/04
Great Plains Mfg., Inc.
Flex Limiter Bars
Refer to Figure 1-2:
1.
Position the flex-limiter bars so that the slots line up with
the holes in the lugs near the center of the implement.
2. Install the 7/8 x 3 1/2-inch bolts (1), flat washers (2),
spacer tubes (6), flex-limiter bars (3), lock washer (4),
and nut (5) at each end of tube. The flex-limiter bars
should be free to move from side-to-side on the bolts.
Figure 1-2
Flex Limiter Bar Installation
14483
Lift Cylinder Hydraulic Hoses
Refer to Figure 1-4 or Figure 1-5. Install the hydraulic hos-
es on the lift wheels. Note the hose lengths listed and be
sure to use the correct length of hose in each location. In-
stall the longest hose first and work down to the shortest
hose length.
Refer to Figure 1-3. The row openers in some locations have
hose clips (1) mounted on them. Always route hydraulic hos-
es through the clips to prevent damage.
IMPORTANT: Carefully check hoses to be sure they
are not rubbing on any sharp edges. Check that the
hoses are loose enough to allow the implement to fold
or unfold and raise or lower without damage. Be sure
that hoses will not bind or get pinched during opera-
tion.
NOTE: The SAE O-ring and JIC 37˚ flare-type hose con-
nections do not require sealant for reconnecting. They do
not require high torque for a good seal.