Pre-transport checklist – Great Plains 3N4010HDA Operator Manual User Manual
Page 32
28
3N-4010HDA
Great Plains Manufacturing, Inc.
196-444M
2013-09-24
Pre-Transport Checklist
Before transporting the cart, check and observe the
following items.
❑ Make sure the weight of the tractor equals or
exceeds 67% the complete air drill assembly.
❑ Air Cart Checklist Complete
Including: cart drive chain locked-out, auger latched,
hopper lids secured, ladders latched up.
❑ Marker Checklist Complete
Markers must be folded in transport carriers.
❑ Drill Folded and Locked
❑ Tires
Check that all tires are properly inflated as listed on
“Tire Inflation Chart” on page 74.
❑ Bystanders
Check that no one is in the way before moving. Do
not allow any one to ride on the cart or drill.
❑ Warning Lights
Always use tractor, cart and drill warning lights when
transporting the air drill.
❑ Clearance
Know the maximum dimensions of the cart and drill
in transport position and follow a route that provides
adequate clearance from all obstructions, including
overhead lines.
See “Specifications and Capacities” on page 74.
❑ Stopping Distance
Allow sufficient stopping distance and reduce speed
prior to any turns or maneuvers. If the cart is trans-
ported full, allow extra stopping distance.
❑ Road Rules
Comply with all national, regional and local laws
when transporting on public roads.
❑ Watch Traffic
The cart hoppers obstruct a portion of your rear view.
Be prepared for sudden maneuvers from following
vehicles.
Figure 24
Review Transport Checklist
27114