Great Plains V-300F Operator Manual - Manual (Page 55)

Great Plains Manufacturing, Inc. Monitor Operation 51
11/15/2007 148-057M-A
Manual S.S.F. Entry
For a typical V300, firm dry ground, nominal wheel slip-
page and new tires inflated to factory specification, the
calculated calibration figure is:
3.235 meters (Metric units mode) or
127.4 inches (Imperial units mode).
Note: The factory default is 2.000 (meters) or 78.78 (inch-
es), and is not correct for the V300/V300F.
To change the S.S.F:
1. Channel Select to Forward Speed .
Refer to Figure 51
2.
Press and hold the to enter Program Mode 1.
The units of measure display (see page 47) appears
for a few seconds. Continue holding the button until a
numeric display appears.
3. While continuing to hold , use Channel Select
to select a digit, and then the decimal point.
Continue to hold to cycle slowly between 0-9
and decimal point positions. Release at desired
values.
4. While continuing to hold , press again to
select the next display element, and hold to change.
Repeat until the desired value is entered.
5. Release to save the new values.
Figure 51
Nominal S.S.F. Value (m)
22632