Shank mounting, No-till shanks – Great Plains Max Cover Verti-Till Ripper Operator Manual User Manual
Page 22
Advertising
5, 7, & 9 Shank
596-098M
8/6/07
20
Shank Mounting
No-Till Shanks
Refer to Figure 8
1.
Attach the no-till shank (shown) (1) to the auto re-
set shank mount (shown) (2) using 3/4” x 6”
GRD8 bolts (3), 3/4” hardened flat washers (4),
3/4” lock washers (5) and 3/4” nuts (6).
2.
Place two flat washers (4) against the head of the
bolt (3) and one flat washer (4) next to the lock
washer (5).
NOTE: Extra hardened washers allows use of longer
bolt to keep threads out of the shear area.
3.
Torque bolts (3) to 400 FT LBS.
IMPORTANT: Torque bolts (3) to 400 FT LBS.
Note: Mounting to the rigid shank mount will use same
hardware and instructions.
22740
Figure 8
No-Till Shank Mounting
Advertising