Great Plains 4336 DH Operator Manual - Manual (Page 23)

Great Plains Manufacturing, Inc. Table of Contents Index Preparation and Setup 19
05/22/2012 Table of Contents Index 556-100M
Refer to Figure 16
Note: The mounting holes in the dual scraper brackets are
slotted. This will allow the scraper to be adjusted close
to the disc blade.
33. Adjust the scraper by loosening the 3/4 x 7 1/2 hex
bolts on lower part of c-flex and slide bracket until it is
about an 1/8” from disc blade .
Figure 16
Dual Scraper Adjustment
42124
1
2
1
1
2
3