Great Plains 3P1006NT Operator Manual - Manual (Page 23)

2011-12-20 Table of Contents Index 151-144M
Great Plains Manufacturing, Inc. Table of Contents Index 19
Operating Instructions
This section covers general operating procedures.
Experience, machine familiarity and the following
information will lead to efficient operation and good
working habits. Always operate farm machinery with
safety in mind.
Pre-Start Checklist
High Pressure Fluid Hazard:
Escaping fluid under pressure can have sufficient pressure to
penetrate the skin. Check all hydraulic lines and fittings before
applying pressure. Fluid escaping from a very small hole can
be almost invisible. Use paper or cardboard, not body parts,
and wear heavy gloves to check for suspected leaks. If injured,
seek immediate medical attention from a physician familiar
with this type of injury.
1. Carefully review “Important Safety Information”
starting on page 1.
2. Lubricate drill as indicated under “Lubrication and
Scheduled Maintenance” on page 54.
3. Check all tires for proper inflation. See “Tire
Inflation Chart” on page 65.
4. Check all bolts, pins and fasteners. Torque as shown
in “Torque Values Chart” on page 66.
5. Check drill for worn or damaged parts. Repair or
replace parts before going to the field.
6. Check hydraulic hoses, fittings and cylinders for
leaks. Repair or replace before going to the field.
7. Rotate each ground drive wheels to see that the
drives and meters are working properly and free
from foreign material.
8. Check that the caster pivots are unlocked.
Falling hazard:
Watch your step when walking on drill ladder and walkboard.
Falling from drill could cause severe injury or death.
WARNING
To avoid serious injury or death:
Watch your step when climbing ladder or
walking on walkboard.
838-102C