Drill lift/lower (s/n a1059w+), Raising, Raising after transport, parking or storage – Great Plains 3P1006NT Operator Manual User Manual

Page 24: Raising for transport, parking or storage

Advertising
background image

20

3P1006NT

Table of Contents

Index

Great Plains Manufacturing, Inc.

151-144M

Table of Contents

Index

2011-12-20

Drill Lift/Lower (s/n A1059W+)

(applies to drills with serial numbers A1059W+

For serial number A1058W-, see page 21)

Raising and lowering the drill relies on the tractor 3-point
lift arms in front, and hydraulic lift-assist cylinder at rear.
When setup for field use, the hitch and lift circuits may be
operated in any order, or simultaneously. Both, however,
must be lowered for planting, and the lowered hitch
height must be as established at step 15 on page 16.

Raising
1.

Raise the tractor 3-point lift arms fully.

2.

Activate the lift circuit lever to Extend the lift-assist
cylinder fully. Set circuit to Neutral.

Crushing Hazard:
Rely on circuit Neutral to hold the drill raised only for field
turns. Use parking stands and lock channel for all other raised
operations, transport, parking, maintenance and storage.

Raising after Transport, Parking or Storage

Refer to Figure 10 and Figure 11
3.

If raising for planting, remove lock channel

from

lift-assist cylinder. Store in the pin hole

of the right

side of lift assist weldment.

4.

Install stroke control spacers

. Remove needed set

from rod

on lift-assist weldment and clamp around

cylinder rod

. Use a locally developed spacer

combination (see page 17).

Raising for Transport, Parking or Storage

Refer to Figure 10 and Figure 11
5.

If raising for transport or storage, set lift circuit to
neutral to hold at raised. Set tractor parking brake
and shut off tractor.

6.

Remove stroke control spacers

from lift-assist

cylinder. Store spacers on weldment rod

.

Note: If recently developed or changed, make a note of

the combination removed.

7.

Install lock channel

on cylinder rod. Secure with

pin.

8.

Start tractor.

9.

Slowly move the lift circuit lever to Retract, allowing
the cylinder to settle on the lock (and relieving
pressure from the hydraulic system).

Figure 10

Lock Channels (s/n A1059W+)

31920

1

2

1

2

Figure 11

Stroke Control Spacers (A1059W+)

32057

1

5

3

4

3

4

5

5

4

1

Advertising