Great Plains Gauge Wheel-Spindle - Manual (Page 12)

Great Plains Mfg., Inc.
12 Dual Gauge Wheel/Spindle Update
195-080M 04/10/2009
Install Spacer Tubes
Refer to Figure 19
53. Apply anti-seize compound to the exposed, non-
threaded portions of the spindle outside the weld-
ment.
54. Select two saved:
120-198D AXLE SPACER TUBE
Place the spacers over the spindle shaft and inside
the bearing seals.
Align and Secure Keyless Hub
Temporarily Install a Wheel Hub
Refer to Figure 20 and Figure 28 on page 17
55. Select one new or saved wheel hub:
152-390D 6-BOLT HEAVY DRIVE HUB 2 BORE
and one set new or saved:
802-687C HHCS 5/8-11X4 SPTHD GR8
804-095C WASHER FLAT 5/8 HARD ASTMF436
803-263C NUT HEX FLANGE LOCK 5/8-11 PLT
Mount the hub on the blunt (non-threaded)
end of the spindle . Take care to avoid moving
the spindle so much that it contaminates the keyless
hub with bearing grease or anti-seize compound.
56. Loosely secure the hub with bolt ,
washer and flanged lock nut .
Fi S
Figure 19
Install Spacer Tube
29454
51
51
Fi S
Figure 20
Temporarily Mount Wheel Hubs
29455
12
25
30
52
14
12 52
19 57
22 61
21 60
12 52
14
19 57
22 61 21 60