Great Plains Gauge Wheel-Spindle - Manual (Page 13)

Great Plains Mfg., Inc.
Installation Instructions 13
04/10/2009 195-080M
Refer to Figure 21
57. Select one of each new:
195-234D WASHER FLAT 2 ID X 2 5/8 X 10G
195-354D WASHER FLAT 2 ID X 2 5/8 X 16G
Place these washers and on the threaded
end of the spindle. These are to ensure that the hub
on the other end of the spindle fully seats.
58. Select one new or saved wheel hub:
152-390D 6-BOLT HEAVY DRIVE HUB 2 BORE
and one set new or saved:
802-687C HHCS 5/8-11X4 SPTHD GR8
804-095C WASHER FLAT 5/8 HARD ASTMF436
803-263C NUT HEX FLANGE LOCK 5/8-11 PLT
Mount the hub on the threaded end of the
spindle .
59. Select one each new or saved:
804-182C WASHER HARD 1 1/2 MILCARB GR8
803-239C NUT HEX SLOTTED 1 1/2-12 PLT
Place the washer on the threaded end of the spin-
dle, and add the nut
or . Slowly tighten the nut
just until there is no side-to-side play in the spindle.
Rotate spindle to ensure bearings seat.
60. Select one set new or saved:
802-687C HHCS 5/8-11X4 SPTHD GR8
804-095C WASHER FLAT 5/8 HARD ASTMF436
803-263C NUT HEX FLANGE LOCK 5/8-11 PLT
Loosely secure the hub with bolt ,
washer and flanged lock nut . If the
cross bolt cannot be passed through the hub, it may
be necessary to remove one of the washers
installed at step 57.
IMPORTANT !
To protect the seals during keyless hub tighten-
ing, and sure proper spacing for keyless hub
alignment, the spindle must be fully seated in the
bearings. Do not over-tighten.
Figure 21
Remove Play and Seat Bearings
29470
59
20
63
23
16
13
13
16
13 16
12 52
19 57
22 61
21 60
12 52
14
23 63
20 59
20 59
19 57
22 61
21 60
19 57
22 61 21 60