Great Plains DVN8324 Assembly Manual - Manual (Page 28)

24 8315-8324DVN Great Plains Manufacturing, Inc.
550-466Q-ENG 11/25/2013
Refer to Figure 24
North American Light Assembly
106.Fasten light bracket LH to stub plate of center
frame with 1/2 x 1 1/2 hex bolts , 1/2 lock washers
and 1/2 huts. Repeat same procedure for light
bracket RH
.
107.Attach light mounting brackets to front side tube
shown, of center frame, with 1/2 x 4 1/32 x 4 u-bolts
, 1/2 lock washers and 1/2 huts.
108.Attach smv post to back side of same tube as light
mounting brackets , as close to center as possible.
Secure with 1/2 x 4 1/32 x 4 u-bolts , 1/2 lock
washers and 1/2 huts. Attach smv sign to back
side of smv post , secure with 1/4 x 3/4 pan head
screws , 1/4 lock washers and 1/4 nuts.
109.Route light harness 30’ lead from front of hitch
(tractor plug to front), along same route as hydraulic
hose (fasten in same clamps and hose wraps as
hoses). Plug one end of enhance light module to
small end of light harness 30’ lead . Plug bigger
end of wishbone light harness into other end of
enhance light module . Route other ends over
towards (marked left and right) the light mounting
brackets as shown.
110.Mount red lamp lights to top of light mounting
brackets , with 1/4 x 1 hex bolts and 1/4 lock
nuts.
111.Mount amber lamp lights to top of light brackets
and , with 1/4 x 1 hex bolts and 1/4 lock nuts.
112.Tighten all bolts to specs. Be sure and get all wiring
harnesses fastened up securely with hose wraps or
clamps (if routed close to hydraulic hoses) or use
cable ties
.
1
3
2
4
5
6
4
5
7
6
8
9
10
9
11
10
12
4 14
13 1
2 14
15