Connect wiring harness – Great Plains DVN8324 Assembly Manual User Manual
Page 38
34
8315-8324DVN
Great Plains Manufacturing, Inc.
550-466Q-ENG
11/25/2013
Connect Wiring Harness
181.Slide rubber end piece
back from outer casing
of
plug.
182.Remove screws
from outer casing of European light
harness plug
. Pull outer casing apart.
Note: Be sure to hook black wire of retract wire harness
to keyed power terminal on rear of plug
. See
owners manual of tractor to determine which ter-
minal to hook black wire to. If hooked to constant
power terminal, this will decrease battery life as
solenoids will cycle constantly.
183.Thread retract wire harness
through rubber end
piece
starting with smaller ends.
184.Remove the two screws
holding the metal plate
.
185.Loosen screw
(terminal 3), in retract wire harness
plug
, slide white wire along side of existing white
wire (terminal 3) and re-tighten screw
.
186.Repeat same procedure for black wire.
187.Re-connect the metal bar
with the two screws
.
188.Align plug in bottom of outer casing.
Note: Be sure plug and slot in casing are properly
aligned, otherwise casing will not fit correctly.
189.Re-install screw
to secure outer casing
.
190.Slide rubber end piece
back onto back side of outer
casing
Figure 29
Lighting Connector (European)
41926
1
7
2
3
4
4
2
7
5
6
1
2
3
2
5
4
4
1
4
5
6
7
6
5
4
3
2
1
2