Great Plains 3S-3000HDF Operator Manual v1 - Manual (Page 30)

26 3S-3000/F/HD/HDF Table of Contents Index Great Plains Manufacturing, Inc.
195-441M Table of Contents Index 2014-07-01
Transport Lift
1. Fold the drill (unless this lift is for maintenance or
adjustment). See “Folding” on page 24.
2. If the Two Outlet conversion kit is installed, a selector
valve near the hitch must be operated to switch
between Transport Lift and Opener Lift. See “Lift
Selector Valve Operation” on page 42.
3. Supply oil to the base (extend) ends of the Transport
Lift cylinders.
Refer to Figure 17
4.
Leave the circuit extended until mainframe lift is
complete, the transport hooks have engaged, the
wing ends are lifted off the ground, and the front box
lift cylinder is fully extended.
Refer to Figure 18
5.
Swing the locks up and onto the transport lift
cylinders. They are temporarily held in place with
polymer bumpers. They are firmly held in place when
the cylinder is relaxed in step 7.
6. Rotate cylinder lock channel over rod on front box lift
cylinder.
Note: Bumpers hold the transport lift cylinder lock
channels in place temporarily. The channels will
remain in position when cylinders settle against
channels.
7. Slowly reverse the Transport Lift circuit lever until all
three lock channels are resting firmly on the rod
ends of the transport lift and box lift cylinders. Set
circuit lever to off.
The drill is now ready for the pre-transport checklist. See
“Transport” on page 27.
FigureSpacer
Figure 18 - Fold
Transport Lift Cylinder Lock
15552