Great Plains 3S-3000HDF Operator Manual v1 - Manual (Page 83)

Great Plains Manufacturing, Inc. Table of Contents Index Maintenance and Lubrication 79
2014-07-01 Table of Contents Index 195-441M
Toolbar Height
Refer to Figure 85 and Figure 86
Toolbar height above ground level is factory set and
normally does not require adjustment. If you tear down
the drill for repair, or if the tool bar is visibly not level,
spacer washers
on vertical pivot pins allow for a small
amount of tool bar-height adjustment.
To check tool bar height, park drill on a level surface, and
check for correct tire inflation. Measure from ground to
horizontal pivot pin
. If dimension on either side of drill
varies more than 1 ⁄
4
inch (6.4mm), adjust tool bar height.
FigureSpacer
To adjust tool bar height, reposition spacer washers .
First lower openers and set enough opener down
pressure to help balance frame. Raise tool bar by
removing spacer washers from top of the vertical pivot
and placing them on bottom side of pivot. Lower tool bar
by removing spacer washers from bottom of vertical pivot
and placing them on top of pivot.
FigureSpacer
Figure 85
Toolbar Height
15616
1
2
1 2
3
1
FigureSpacer
Figure 86
Toolbar Height Adjustment
15617
3
3