Great Plains NTA1300 Predelivery Manual - Manual (Page 10)

8 NTA 1000 and NTA 1300 148-528Q 7/29/2004
Great Plains Mfg., Inc.
“H” Frame, Sub-Frame and Box
Refer to Figure 11
1. Center and assemble sub-frame (1) to the “H” frame
(2) using 3/4 x 6 1/32 x 5 u-bolts, lock washers and hex
nuts.
2. Place box (3) on frame (1) using clamp plates (4) and
fasteners. (20mm x 15cm, HHCS bolt, flat washer,
lock washer and nuts). Fasten box to frame using
12mm x 30mm hex bolts, flat washers, lock washers
and nuts (5).
3. Up to three spacers can be used in each place to
space between the support angle and the “H” frame
support tube (6). They are held in place using a 1/4 flat
washer and a 1 1/4 x 1 self-tapping screw.
Refer to Figure 12
NOTE: Center the frames when assembling together. See
figure 12 for measurements between frames.
19413
19440
Figure 11
“H” Frame to Sub-frame to Box
Figure 12
Centering Frames
Assembly