Great Plains NTA1300 Predelivery Manual - Manual (Page 5)

3 7/29/2004 NTA 1000 and NTA 1300 148-528Q
Great Plains Mfg., Inc.
The following headings are step-by-step instructions for
assembling the NTA 1000 and NTA 1300. Begin with Tools
Required and Pre-Assembly Checklist to make sure you
have all necessary parts and equipment. Then proceed
with Assembling NTA 1000 and NTA 1300. Follow each
step to make the job as quick and safe as possible and
produce a properly working machine.
The NTA 1000 and NTA 1300 are shipped via flat bed
truck. It is the dealer’s responsibility to unload the new ma-
chine. Unload all equipment before beginning assembly.
Do not attempt any assembly work while the implement is
on the truck.
Tools Required
•
Forklift or overhead hoist
•
General hand tools
Pre-Assembly Checklist
1. Read and understand “Important Safety Informa-
tion” on page 1 before assembling.
2. Have at least two people on hand while assembling.
3. Make sure the assembly area is level and free of ob-
structions (preferably an open concrete area).
4. Have all major components.
5. Have all fasteners and pins shipped with the hitch.
6. Have a copy of the parts manual on hand. If unsure of
proper placement or use of any part or fastener, refer
to the parts manual.
7. Check that all working parts are moving freely, bolts
are tight and cotter pins are spread.
8. Check for proper tension and alignment on all drive
chains.
9. Check that all safety decals and reflectors are correct-
ly located and legible. Replace if improperly located or
damaged. Refer to Safety Decals, “Important Safety
Information” in the operator’s manual.
10. Inflate tires to recommended pressure as listed on the
Tire Inflation Chart on the “Appendix” on page 32.
Tighten wheel bolts as specified on Torque Values
Chart on the “Appendix” on page 32.
IMPORTANT: If a pre-assembled part or fastener is
temporarily removed, remember where it goes. Keep
the parts separated.
Introduction