Electrical hookup, Raise parking stands, Electrical hookup raise parking stands – Great Plains LC40 Operator Manual User Manual
Page 20
16
LC40
Great Plains Manufacturing, Inc.
591-049M
2014-07-21
Electrical Hookup
Plug implement electrical lead in tractor seven-pin
connector. If your tractor is not equipped with a seven-pin
connector, contact your dealer for installation.
Plug in any optional connectors or aftermarket
connectors, such as an implement-mounted GPS
receiver. For future reference, note any optional
connectors on this checklist.
❑
Lighting connector (standard)
❑ __________________________
❑ __________________________
Raise Parking Stands
Use the tractor 3-point hitch to raise the implement
just enough to relieve weight on the parking
stands
2.
Remove pin
securing the stand.
3.
Raise the stand using the welded loop
4.
Re-insert the pin in through the lower hole of the
frame tube, and the lowest hole of the stand. Secure
pin with hairpin cotter.
Figure 7
Lighting Connector
36051
1
1
Figure 8
Parking Stand Raised
34865
1
3
2
3