Great Plains 1006 Assembly Instructions - Manual (Page 10)

151-118M 8/2/2005
Great Plains Mfg., Inc.
Option Installation 10
Native Grass
1. Lower drill to the ground.
2. Remove walkboard, walkboard mounts and
walkboard supports. Save hardware.
3. Remove and save all box handles and hard-
ware.
4. Assemble new walkboard end panels and
harrow supports. Re-attach existing ladder to
left-hand walkboard end using hardware re-
moved in step 2.
Refer to Figure 12
5. Attach the native grass seed box mount
brackets (1) to the native grass seed box (2)
where the native grass seed box partitions
are located. Use the bolts and nuts holding
the partitions. (On 706NT models, these
brackets are not used.)
6. Mount the native grass seed box (2) to the
seed box using 1/2" x 1 1/4" bolts and 1/2"
flange nuts on the outside ends. Use existing
bolts and nuts from the seed box partitions to
attach the box mount brackets (1). Use 1/2" x
1" bolts, 1/2" lock washers and 1/2" nuts to at-
tach the box to the drill frame.
7. Attach the handles (3) removed in step 3 to the
native grass seed box (2) using the hardware
removed in step 3.
Native Grass Seed Drive
8.
Support right-hand drill and gauge wheel arm
by blocking up with jacks and supports. Re-
move gauge wheel tire.
Figure 12
Native Grass Seed Box
22566