B&G Zeus 12 - Manual (Page 12)

11
Basic Operation 2.
Turning the Unit On/Off
POWER ON STAND BY POWER OFF
PWR
PWR
PWR
3 s
If you turn the unit ON when no external equipment is connected you will be asked to
run in simulator mode.
When you turn ON the system after the first-time initialization, the system will start with
the same page and settings that were activated when the system was turned OFF.
If the radar is running you can turn it to standby mode from
within the Light dialog.
Positioning a Man Over Board Mark
If an emergency situation should occur, you can position a Man Over Board waypoint at
the vessel’s current position by pressing and holding the number ‘1’ key.
When you activate the MOB function the following actions are automatically performed:
a MOB waypoint is positioned at the vessel’s position
-
the display switches to a zoomed
-
Chart panel, centered on vessel position
Zeus starts navigating towards the MOB waypoint
-
MOB 1
3 s
Zeus will continue navigating towards the MOB point until
the waypoint is reached or until you select to stop this
navigation.
PWR
PLOT GO TO
MARK VESSEL