Bio-Rad CHEF Mapper® XA System - Manual (Page 27)

After the data for Block 2 run time are entered, the screen will appear for Block 2, State 1:
Blk2 St01: Enter values for voltage gradient (V/cm), angle (Ang), initial switch time (In Tm), final
switch time (Fn Tm), and ramping factor (a) in the same manner as Block 1, States 1 and 2.
After Block 2, State 1 parameters are entered, the screen will ask if another State is desired.
Continue with another State?: If another state is desired, press 1, then ENTER. If another
state is not desired, press 0, then ENTER.
For example, a second vector in Block 2 would be programmed from the following screen:
Blk2 St02: Enter values for voltage gradient (V/cm), angle (Ang), initial switch time (InTm),
final switch time (FnTm), and ramping factor (a) in the same manner as for Block 1, States
1 and 2.
After State 2 parameters are entered, the screen will ask if another state is desired. You
can enter up to 15 states per block.
Continue with another State?: If another state is needed, press 1, then ENTER. If another
state is not needed, press 0, then ENTER.
Continue with another State (Vector) ? [ ]
Blk2 St02 [ ]Vc/m a = [ ]
Ang = [ = [ . FnTm = [ . ]
Continue with another State (Vector) ? [ ]
Blk2 St01 [ ]Vc/m a = [ ]
Ang = [ = [ . FnTm = [ . ]
23