Bio-Rad CHEF Mapper® XA System - Manual (Page 30)

Running Multi State
While a multi state program is being run, the following screens are displayed:
Screen 1
Blk: Block number.
St: State number.
V/cm: Voltage gradient of the present state.
Angle: Angle of the present vector.
I: Indicates the interrupt is on.
Blk time remaining: The time remaining to the end of the run (i.e.: a countdown clock).
ma: The current in milliamperes.
Screen 2
Blk: Block number.
St: State number.
Sw.tm: The present switch time. This will change during a ramp.
volts: The actual voltage of the run.
Run time: The total run time, shown in hours or minutes.
Screen 3
Blk: Block number.
St: State number.
Intrp: Indicates an interrupt for that state (0 = no, 1 = yes).
Ang.: The angle of the interrupt vector.
V/cm: The voltage gradient of the interrupt vector.
Blk___St__ Intrp = __ Ang. = ___ ____V/cm
Duration = ____
Blk___St__ ___
Sw.Tm = hh:mm:ss
l
Blk___St__ ___V/cm Angle = _____ l
Blk Time Remaining = hh:mm
____ma
26