Bio-Rad ChromLab™ Software - Manual (Page 169)

Using the C-96 Autosampler with NGC Systems
Installation Guide | 167
8. On the back of the autosampler:
a. Insert the 15-pin cable into the left (P1 RELAYS OUTPUTS) connector port
and tighten the thumbscrews.
b. Insert the 9-pin cable into the right (P2 INPUTS) connector port and tighten
the thumbscrews.
9. On the back of the SIM:
a. Insert the P1 RELAYS OUTPUTS cable into the DIGITAL IN port.
b. Insert the P2 INPUTS cable into the DIGITAL OUT port.