Bio-Rad Model EG-1 Econo™ Gradient Monitor User Manual
Page 16
13
Appendix A
Fuse Replacement
Figure A. Fuse removal.
1. Disconnect unit from power source.
2. Remove the fuse cover with a small-blade screwdriver or similar tool.
3. Pull the fuse holder out of the fuse compartment and, if necessary,
replace the fuse. Use 5 mm x 20 mm fuse, type T, 1A.
4. Reinsert the fuse holder, with fuse, into the fuse compartment.
Appendix B
Rear Panel Connections
The signal output
socket is an 8-pin circular mini-DIN. The fol-
lowing information is provided for those wishing to interface the Model
EG-1 Econo Gradient Monitor with equipment such as integrators or chart
recorders which do not utilize banana plug connectors.
Pin
Function
1
No Contact
2
No Contact
3
No Contact
4
No Contact
5
Chart Recorder (+)
6
Chart Recorder (-)
7
No Contact
8
No Contact
Pin configuration
M7318150H 2/27/1 2:06 PM Page 13