Dell Latitude E6510 - Manual (Page 21)

Back to Contents Page
I/O Board
Dell™ Latitude™ E6510 Service Manual
Removing the I/O Board
1. Follow the procedures in Before Working Inside Your Computer .
2. Remove the battery .
3. Remove the access panel .
4. Remove the subscriber identity module (SIM) card .
5. Remove the optical drive .
6. Remove the keyboard .
7. Remove the coin-cell battery .
8. Remove the hinge covers .
9. Remove the display assembly .
10. Remove the hard drive .
11. Remove the Latitude ON™ flash card .
12. Remove the wireless wide area network (WWAN) card .
13. Remove the wireless local area network (WLAN) card .
14. Remove the heat sink and fan assembly .
15. Remove the processor .
16. Remove the palm rest assembly .
17. Remove the Bluetooth® card .
18. Remove the ExpressCard board .
19. Remove the system board .
20. Remove the screw (labeled 'I') that secures the I/O board to the computer.
21. Remove the screws that secure the I/O board to the computer.
22. Remove the I/O board from the computer.
Replacing the I/O Board
To replace the I/O board, perform the above steps in reverse order.
Back to Contents Page
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE: You may need to install Adobe™ Flash Player™ from Adobe.com in order to view the illustrations below.