Dell Latitude E6510 - Manual (Page 36)

Back to Contents Page
Palm Rest Assembly
Dell™ Latitude™ E6510 Service Manual
Removing the Palm Rest Assembly
1. Follow the procedures in Before Working Inside Your Computer .
2. Remove the battery .
3. Remove the access panel .
4. Remove the optical Drive .
5. Remove the keyboard .
6. Remove the hinge Covers .
7. Remove the fingerprint reader .
8. Remove the display assembly .
9. Remove the screws that secure the palm rest to the bottom of the computer.
10. Remove the screws that secure the palm rest to the computer.
11. Disconnect the Smart Card, speakers, touchpad, and RFID (if applicable) cables from their connectors on the system board.
NOTE: If you purchased your computer with a contactless Smart Card reader, you must disconnect the RFID cable.
12. Release the palm rest from the computer:
a. Starting from the back of the computer, lift the right side of the palm rest to release it from the computer.
b. Gently pull the palm rest forward and flip the palm rest over.
13. Disconnect the HAL sensor cable from the system board.
14. Remove the palm rest from the computer.
Replacing the Palm Rest Assembly
To replace the palm rest assembly, perform the above steps in reverse order.
Back to Contents Page
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE: You may need to install Adobe™ Flash Player™ from Adobe.com in order to view the illustrations below.