Dell Latitude E6510 - Manual (Page 50)

Back to Contents Page
System Board
Dell™ Latitude™ E6510 Service Manual
Removing the System Board
1. Follow the procedures in Before Working Inside Your Computer .
2. Remove the battery .
3. Remove the subscriber identity module (SIM) card .
4. Remove the optical drive .
5. Remove the keyboard .
6. Remove the coin-cell battery .
7. Remove the hinge covers .
8. Remove the hard drive .
9. Remove the Latitude ON Flash™ card .
10. Remove the wireless wide area network (WWAN) card .
11. Remove the wireless local area network (WLAN) card .
12. Remove the display assembly .
13. Remove the heat sink and fan assembly .
14. Remove the processor .
15. Remove the palm rest assembly .
16. Remove the ExpressCard board .
17. Remove the Bluetooth® card .
18. Release the cable tab and disconnect the SD media board cable from the system board.
19. Remove the screws that secure the system board to the chassis.
20. Disconnect the system board from I/O board, and flip the system board over.
s
21. Disconnect the DC-in cable from the system board.
22. Remove the system board from the chassis.
Replacing the System Board
To replace the system board, perform the above steps in reverse order.
Back to Contents Page
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE: You may need to install Adobe™ Flash Player™ from Adobe.com in order to view the illustrations below.