After starting, Turbocharger “cool down” — if equipped, Engine block heater — if equipped – Dodge 2015 Dart - Owner Manual User Manual

Page 422

Advertising
background image

CAUTION!

To prevent damage to the starter, do not continuously
crank the engine for more than 25 seconds at a time.
Wait 60 seconds before trying again.

After Starting

The idle speed will automatically decrease as the engine

warms up.

Turbocharger “Cool Down” — If Equipped

This vehicle is equipped with an after-run pump to cool

the turbocharger after the engine is shut off. Depending

on the type of driving and the amount of cargo, the pump

will run for up to 10 minutes after the engine has been

shut off to circulate coolant through the turbocharger.

Although the pump is rubber-mounted for quiet opera-

tion, it is normal to hear it running during this time.

ENGINE BLOCK HEATER — IF EQUIPPED

The engine block heater warms the engine and permits

quicker starts in cold weather.
Connect the cord to a 110-115 Volt AC electrical outlet

with a grounded, three-wire extension cord.
The engine block heater is required for 1.4L Turbo engine

below -20°F (-29°C) and for the 2.4L engine below -29°F

(-34°C). It is recommended for the 2.0L engine and 2.4L

engine below -20°F (-29°C).
The engine block heater cord is routed under the hood,

behind to the driver’s side headlamp. Follow the steps

below to properly use the engine block heater:
1. Locate the engine block heater cord (behind the driv-

er’s side headlamp).

2. Undo the Velcro strap that secures the heater cord in

place.

420 STARTING AND OPERATING

Advertising