Programming a non-rolling code – Dodge 2015 Durango - Owner Manual User Manual

Page 248

Advertising
background image

Reprogramming A Single HomeLink® Button
(Rolling Code)
To reprogram a channel that has been previously trained,

follow these steps:
1. Cycle the ignition to the ON/RUN position.
2. Push and hold the desired HomeLink® button until

the indicator light begins to flash after 20 seconds. Do

not release the button.

3. Without releasing the button proceed with “Program-

ming A Rolling Code” step 2 and follow all remaining

steps.

Programming A Non-Rolling Code

For programming Garage Door Openers manufactured

before 1995.
1. Place the ignition in the ON/RUN position.

2. Place the hand-held transmitter 1 to 3 inches (3 to 8 cm)

away from the HomeLink® button you wish to program

while keeping the HomeLink® indicator light in view.

3. Push and hold the Homelink® button you want to

program while you push and hold the hand-held

transmitter button.

4. Continue to hold both buttons and observe the indi-

cator light. The Homelink® indicator will flash slowly

and then rapidly after HomeLink® has received the

frequency signal from the hand-held transmitter. Re-

lease both buttons after the indicator light changes

from slow to rapid.

5. Push and hold the programmed HomeLink® button

and observe the indicator light.

• If the indicator light stays on constantly, program-

ming is complete and the garage door/device should

activate when the HomeLink® button is pushed.

246 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Advertising