Adding washer fluid – Dodge 2015 Durango - Owner Manual User Manual

Page 606

Advertising
background image

4. Install the wiper blade pivot pin into the wiper blade

holder at the end of the wiper arm, and firmly press

the wiper blade until it snaps into place.

5. Lower the wiper blade and snap the pivot cap into

place.

Adding Washer Fluid

This vehicle is equipped with a Driver Information

Display (DID), the DID will indicate when the washer

fluid level is low. When the sensor detects a low fluid

level, the windshield will light on the vehicle graphic

outline and the “WASHER FLUID LOW” message will be

displayed.
The fluid reservoir for the windshield washers and the

rear window washer is shared. The fluid reservoir is

located in the engine compartment, be sure to check the

fluid level at regular intervals. Fill the reservoir with

windshield washer solvent only (not radiator antifreeze).

When refilling the washer fluid reservoir, take some

washer fluid and apply it to a cloth or towel and wipe

clean the wiper blades, this will help blade performance.

To prevent freeze-up of your windshield washer system

in cold weather, select a solution or mixture that meets or

exceeds the temperature range of your climate. This

rating information can be found on most washer fluid

containers.

WARNING!

Commercially available windshield washer solvents
are flammable. They could ignite and burn you. Care
must be exercised when filling or working around
the washer solution.

604 MAINTAINING YOUR VEHICLE

Advertising