Canon PIXMA MP830 - Manual (Page 141)

Chapter 9 139 Changing the Machine Settings
z Auto redial
Enables/disables automatic redialing.
z TX start speed
Selects the fax sending speed.
z Color TX
When faxing color documents using the ADF, selects whether to perform automatic black &
white conversion if the recipient’s fax machine does not support color faxing.
z TX report
Sets whether to print a transmission report after each transmission.
z Dial tone detect
Sets whether to send faxes after detecting the dial tone. Select <ON> to enable this feature and
avoid transmission errors caused when a fax transmission coincides with reception of an
incoming call.
„ RX settings
z ECM RX
Enables/disables ECM reception.
z FAX/TEL auto switch
Specifies the detailed settings when the receive mode is set to <FAX/TEL auto switch>.
z DRPD: Set FAX ring pat.
Sets the distinctive ring pattern the machine gives off when you receive a fax call. If you
subscribe to a DRPD service, set this to match the pattern assigned by your telephone company.
This setting is only available in US and Canada.
Redial times Specifies the maximum number of redial attempts.
Redial interval Specifies the length of time the machine waits between redial
attempts.
Attach TX image When <Print error only> or <Print for each TX> is selected,
sets whether to print the first page of the document below the
transmission report
Ring start time Specifies the length of time to allow the machine to judge
whether an incoming call is fax or a voice call.
Telephone ring time Specifies, in seconds, the time the machine rings for a voice
call.
Default action Sets whether to receive the fax after the specified ring time
has elapsed.