CREATIVE Network Blaster Wireless Access Point Router CW2202 - Manual (Page 26)

Configuring Basic Settings 4-8
Configuring
Internet
connection
settings In order for your Wireless AP Router to access the Internet, its Internet connection
settings have to be configured to suit the protocol that your broadband modem
uses to connect to the Internet.
If you connect to the Internet using a DSL Modem, and the use of your account
requires entering a login name and password, your ISP uses PPPoE. See “PPPoE
connection” on page 4-9.
If you connect to the Internet using a cable modem, your ISP probably uses DHCP.
See “DHCP connection” on page 4-10.
If you connect to the Internet using a DSL Modem, and the use of your account
requires you to manually enter your IP address, subnet mask, default gateway and
DNS servers, see "Fixed IP connection (using static IP address)" on page 4-11.
These Internet
connection
settings depend on
your subscription
with your Internet
Service Provider
(ISP). If you are
not sure of your
configuration,
check with your
ISP.