CREATIVE Network Blaster Wireless Access Point Router CW2202 - Manual (Page 64)

Safety Precautions D-1
Safety Precautions
General Safety
To avoid the risk of fire, electric shock or personal injury, note the following
precautions when using the product:
❑
Do not expose the product to direct sunlight or excessive heat.
❑ Do not place the product in surroundings that exceed 40°C (104°F).
❑ Avoid humid conditions. Do not place the product near a water source or outlet.
❑ Do not clean the product with a damp cloth or liquid cleaner.
❑ Do not put any weight on the product.
❑ Allow only qualified personnel to service or repair the product, if such is necessary.
Exposure to
Radio
Frequency
Caution
❑ The radiated output power of this device is far below the FCC radio frequency exposure
limits. Nevertheless, the device shall be used in such a manner that the potential for
human contact during normal operation is minimized.
❑ The product and any attached external antenna, if supported, shall be placed in such a
manner to minimize the potential for human contact during normal operation.
❑ In order to avoid the possibility of exceeding the FCC radio frequency exposure limits,
human proximity to the antenna shall not be less than 2.5 cm (1 inch) during normal
operation.
❑ The indoor antenna must be totally isolated and does not have a line of sight to an
external GPS antenna, to avoid feedback reflected RF signal.
Power Adapter
Safety Notice
Power Source This product is specially designed for operation within the electrical range(s)
specified on the provided power adapter. Any usage outside of these ranges is at
your own risk.
If you are not sure of the type of power supply to your home, consult your product
dealer or local Power Company.