Removing the front i/o panel and the usb 3.0 ports – Dell Precision T7600 (Mid 2012) User Manual
Page 29
4.
Connect the system fan cables to their connectors on the system board.
5.
Route the system fan cables out of the opening in the system fan module in the direction of the system board.
6.
Slide the larger air duct downwards into the retention tabs until it is secured to the system fan module.
7.
Slide the smaller air duct downwards into the retention tabs until it is secured to the system fan module.
8.
Install the screws that secure the optical-drive bracket to the chassis.
9.
Install:
a) optical drive
b) left cover
10. Follow the procedures in
After Working Inside Your Computer
.
Removing the Front I/O Panel and the USB 3.0 Ports
1.
Follow the procedures in
Before Working Inside Your Computer
.
2.
Remove the front cover.
3.
Disconnect all the cables from the I/O panel.
4.
Remove the screws that secure the front I/O panel to the computer chassis.
5.
Pull the front I/O panel in a direction opposite to the computer to release its edge from the chassis clip.
29