Removing the power switch – Dell Precision T7600 (Mid 2012) User Manual
Page 31
Installing the Front I/O Panel and the USB 3.0 Ports
1.
Place the USB 3.0 module of the front I/O panel and install the screws to secure it in place.
2.
Place the front I/O panel and install the screws to secure it in place.
3.
Re-seat the front I/O panel assembly on the chassis and secure it to the chassis clips on both sides.
4.
Install the screws that secure the front I/O panel to the chassis.
5.
Connect all the cables to the front I/O panel.
6.
Install the front cover.
7.
Follow the procedures in
After Working Inside Your Computer
.
Removing the Power Switch
1.
Follow the procedures in
Before Working On Your Computer
.
2.
Remove the front cover.
3.
Disconnect the power switch cable from the system board.
4.
Remove the front I/O panel.
5.
Press down on the power switch module on the sides to release the power switch from its compartment.
6.
Remove the power switch from the computer.
31