Dell PowerVault MD3820f - Manual (Page 66)

4. To end the session:
a) Select the session that you want to end, and then click End Session.
The End Session confirmation window is displayed.
b) Click Yes to confirm that you want to end the iSCSI session.
NOTE: If you end a session, any corresponding connections terminate the link between the
host and the storage array, and the data on the storage array is no longer available.
NOTE: When a session is manually terminated using the MD Storage Manager, the iSCSI initiator
software automatically attempts to re-establish the terminated connection to the storage array.
This may cause an error message.
Viewing iSCSI Statistics And Setting Baseline Statistics
To view iSCSI statistics and set baseline statistics:
1. In the AMW menu bar, select Monitor → Health → iSCSI Statistics.
The View iSCSI Statistics window is displayed.
2. Select the iSCSI statistic type you want to view in the iSCSI Statistics Type area. You can select:
– Ethernet MAC statistics
– Ethernet TCP/IP statistics
– Target (protocol) statistics
– Local initiator (protocol) statistics
3. In the Options area, select:
– Raw statistics — To view the raw statistics. Raw statistics are all the statistics that have been
gathered since the RAID controller modules were started.
– Baseline statistics — To view the baseline statistics. Baseline statistics are point-in-time statistics
that have been gathered since you set the baseline time.
After you select the statistics type and either raw or baseline statistics, the details of the statistics
appear in the statistics tables.
NOTE: You can click Save As to save the statistics that you are viewing in a text file.
4. To set the baseline for the statistics:
a) Select Baseline statistics.
b) Click Set Baseline.
c) Confirm that you want to set the baseline statistics in the dialog that is displayed.
The baseline time shows the latest time you set the baseline. The sampling interval is the difference
in time from when you set the baseline until you launch the dialog or click Refresh.
NOTE: You must first set a baseline before you can compare baseline statistics.
Edit, Remove, Or Rename Host Topology
If you give access to the incorrect host or the incorrect host group, you can remove or edit the host
topology. Follow the appropriate procedures given in the following table to correct the host topology.
66